how to make an old vhs effect on premier pro

At the present day, the tape was restored in a digital format by an RCA-to-USB converter that connects the VCR to a computer. Now, from that second bit onward, here's how I assumed it went in practical terms: In the '80s or '90s, the movie (my artwork) was restored in a VHS format (with PAL standard) by a telecine machine using the release print. Splitting the output with a Y connector to a stereo recorder works fine.I'm making an artwork and here's how it goes in a nutshell: A fictional movie scene that was (1) shot on film in the '60s, (2) restored in VHS format in the '80s or '90s, and (3) restored again in a digital format in the present day. Since the mono source does not contain two competing signals, phase cancellation is not possible. The only variance is that you have devided the voltage and may experience a drop on db level, this is easily corrected.

You are merely replicating 1 signal in to 2 channels. However, mono to stereo (2 channel mono) does not suffer from this problem. But if the stereo has discrete sounds in either channel, think late 60 recordings where the bass guitar is entirely in the left channel and the guitar on the right, your method of mono would eliminate valuable data.

Conversely, if the two channels contain sympathetic frequencies you could get frequency amplification or new frequencies that were not there before (harmonic distortion). You can run in to the reverse phase cancellation issue like how those active noise cancelling headphones work.

Depending on how the stereo was created you could be dulling some frequencies while boosting others. When going Stereo > mono you may not want to just combine the cables.

How to make an old vhs effect on premier pro